GREPhysics.NET
GR | # Login | Register
   
  GR9677 #26
Problem
GREPhysics.NET Official Solution    Alternate Solutions
This problem is still being typed.
Electromagnetism}Resonance Frequency

One wants to tune one's radio to the resonance frequency (a.k.a. the frequency at which impedance is matched). The resonance frequency of an LRC circuit is given by \omega^2 = 1/LC, where the quantities involved are angular frequency, inductance, and capacitance. Solving for C, one has C=1/(L\omega^2) \approx 1/(2E-6 * 36 * 100E6) =1/(7.2E-11)\approx 0.1E-11 =1E-12. This is choice (C). The hardest part of his problem, of course, is doing the math without a calculator. Easy.


See below for user comments and alternate solutions! See below for user comments and alternate solutions!
Alternate Solutions
There are no Alternate Solutions for this problem. Be the first to post one!
Comments
wittensdog
2009-10-30 13:47:27
I'm noticing that in a lot of cases, you can make some pretty liberal approximations and still be okay for the GRE. In this problem, if you say pi^2 = 10 , and that the broadcast frequency is 100 MHz and not 103.7 MHz, the math becomes amazingly faster. Now, with approximations like that, we're certainly adding some small errors, but in the case of the frequency it's in the third significant digit, and the difference between pi^2 and 10 in reality is only about 0.13. Now, the answer you get with this method is (1/8) * 10 ^ -11, which works out to be 1.25 * 10 ^ -12, or about a picoFarad. Without even knowing the decimal value of 1/8, you can see that we're on the order of 10 ^ -12. So we're probably looking at choice C.

The next closest choice is D, but that's a factor of 5 lower. Now, we may not know exactly how good our approximations are, but we're definitely not talking about factors of 5 in error here. And going the other way to choice B would be an error factor of 50!

So forget the extra significant digits, there's no point in getting your results to that kind of accuracy when the answer choices are so widely spaced out. The extreme case occurs when the answer choices are separated by like factors of 1000, then don't even bother with the factors at all, just look at powers of ten and shoot for the right ballpark.

Sometimes even when I've been trying to discriminate between two close choices, I've noticed that just paying attention to whether my approximation is shooting me too high or too low will let me get to the right answer.

So, despite my long rambling, my point is, I don't think the math in this problem is hard at all, so long as you toss out accuracy you don't need.
NEC
chemicalsoul
2009-10-17 01:31:46
w^2=(1/LC)-(R/2L)^2
Using this formula, I got ans approx equal to 0.5*10^-11.
Prologue
2009-10-20 12:44:18
w is not equal to 103.7 MHz, f is. And using 2 \pi f=w you see that you need to multiply 103.7 MHz by 2\pi to get omega.
anum
2010-11-08 09:07:23
that's the mistake i did.
RusFortunat
2015-10-20 14:07:36
not just you
NEC
Walter
2009-01-05 15:34:46
The resonant frequency of an LRC-circuit depends on R, in fact

\omega_{d}^2 = \omega_{0}^2 - \frac{R^2}{4L^2}

where \omega_0 is the resonant frequency of the undamped LC circuit, so before grinding out an answer you would need to check that \omega_{0} \gg  \frac{R^2}{4L^2} which you can do as for all the possible answers the magnitude of L is such that the prior condition applies and thus \frac{R^2}{4L^2} can be neglected.

It's a bit gung-ho given how mean some questions are to just ignore the resistance.
wittensdog
2009-10-16 19:37:45
This is indeed the natural oscillation frequency of an RLC circuit, but you still don't need to consider the resistance, for the following reason.

The condition that,

1/w = sqrt(LC)

actually comes from considering the impedance of an RLC circuit. For a given resistance, the largest possible power is dissipated across the circuit when the imaginary portion of the impedance, or the reactance, is zero. So if we specify that we are using a given resistance in the circuit, then the condition for maximum power absorption comes from setting the imaginary portion of the impedance to zero. It turns out that resistors have a purely real resistance, and capacitors and inductors have purely imaginary impedance. So we need to have the sum of the reactances of the capacitor and inductor be zero. Because these reactances are frequency dependent, this then becomes a condition that involves the frequency, inductance, and capacitance, but not the resistance.
syreen
2013-09-11 15:42:22
so, is there a QUICK way to tell whether or not R can be neglected?
maxdp
2013-09-24 22:04:50
Yup. Pretty sure as long as the circuit is hooked up to a power source (as a radio must be), then the power basically "pushes through" the resistor and gives the \omega = 1/\sqrt{LC} that most people in this thread are using. And for the GREs, it seems unlikely that they'd expect you to remember the full formula for the frequency when a power source is not connected (called the damped frequency), which is what Walter is talking about.
NEC
gumpstuck
2008-09-22 21:39:47
Just to clarify and sum up previous comments:

C=1/L\omega^2
here \omega=2\pi\cdot10^8
\omega^2\simeq5\times10^{17}
so we have, C=\frac{1}{(2\times10^{-6})(5\times10^{17})}=10^{-12} which is choice (C).
NEC
gatboja
2005-12-08 12:27:08
yosun, i believe you missed a squared sign for the 100E6.NEC
StudyTime
2005-11-10 20:56:18
Mexicorn, you missed that you need to multiply the broadcast frequency by 2*pi to get the angular freqency.NEC
Mexicorn
2005-11-10 17:20:49
woops, those x's should be multiplications and that -13 should be a positive at the in the last fraction I wroteNEC
Mexicorn
2005-11-10 17:18:34
I'm not sure if i'm doing some math weird, but I can't understand how you got choice C for the problem. Using C=\frac{1}{L\omega^{2}} I end up with \frac{1}{(2x10^{-3})(1.03x10^{8})^{2}} which gives me ~1/2x10^{-13} or (D). Isn't the frequency supposed to be squared? Or am I missing something trivial?
sabinscabin
2008-10-04 14:51:09
you're squaring the frequency, not omega. it's not 1.03e8^2, but (2pi * 1.03e8)^2
NEC

Post A Comment!
You are replying to:
Mexicorn, you missed that you need to multiply the broadcast frequency by 2*pi to get the angular freqency.

Username:
Password:
Click here to register.
This comment is best classified as a: (mouseover)
 
Mouseover the respective type above for an explanation of each type.

Bare Basic LaTeX Rosetta Stone

LaTeX syntax supported through dollar sign wrappers $, ex., $\alpha^2_0$ produces .
type this... to get...
$\int_0^\infty$
$\partial$
$\Rightarrow$
$\ddot{x},\dot{x}$
$\sqrt{z}$
$\langle my \rangle$
$\left( abacadabra \right)_{me}$
$\vec{E}$
$\frac{a}{b}$
 
The Sidebar Chatbox...
Scroll to see it, or resize your browser to ignore it...